Jump to content
Sign in to follow this  
Mr Del

I would have never guessed!!

Recommended Posts

Was clear but a little windy today, so I went to the range anyways. I decided to re-check my .22 disco as to what pellets it liked.( I polished the barrel last week). I started with the 14.3 Crosman hollow point. Not real good. Then the 14.3 wad cutters. Same. Then the 21 gram Barracuda.... same. Then what the hell... why not, I tried the 31 gram ( I call them cannon balls). 25 yards in a 10 mph wind... I could put a dime over the five shots. Who would have thunk? All the rest were 1 1/2 inch 5 shot groups. It is really a lie to call it a group. Shotgun blast tells a true-er story.Going on 70 and still having fun and learning. Thank you!!

Share this post


Link to post
Share on other sites

Mr. Del,For what it's worth I found that my .22cal Disco groups best with the JSB Jumbo's. I shot it over my chrony the other day and it was putting out at right around 900fps. Give them a try if you haven't already.Mc

Share this post


Link to post
Share on other sites

Back when i had my disco it loved the benji 14.1 grain domed it could take chipmunks at 40 yards real fun guns. Sold it to my friend before trying anything heavier looking to get back into a disco set up.

Share this post


Link to post
Share on other sites

I made a mistake. But you sharp people know that allready I checked my tin and it is not 31 grams it is 26, JBS Jumbo Monsters. Again, that pellet sure shoots in my Disco. I made up a tool to ensrue my muzzel break goes on staight. It is a piece if very stiff welding rod about 18 inches long with electrical tape 6 inches apart that just fits the .22 caliber barrel.... and one taped area that just fits the muzzel break at it's nose. I slip the two into the barrel and put the muzzel break on and tighten up the two set screws. Wallaa.

Share this post


Link to post
Share on other sites

My muzzel break is a TKO, work wonderful. I found it very hard to get on straight though. Hence, I made the tool to try out. I think it should come with three set screws(120 drgree opposed) instead of just two.

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
Sign in to follow this  

×